Latest topics
» And you think you got problems?
by Rum Tum Tugger Thu Jan 18, 2018 5:03 pm

» Mk2 Scamp down Brissole way
by Rum Tum Tugger Tue Jan 16, 2018 7:50 am

» One for Bob
by wezgit daan saaf Fri Jan 12, 2018 11:53 pm

» Mk2 part project in NI
by Rum Tum Tugger Mon Jan 08, 2018 9:23 am

» STONELEIGH NATIONAL KIT CAR SHOW
by wezgit daan saaf Sun Jan 07, 2018 12:15 pm

» Brooklands Mini Meet
by wezgit daan saaf Sun Jan 07, 2018 12:13 pm

» Mini Mule (Moke) kitcar
by Mk3rob Thu Jan 04, 2018 7:05 pm

» Turkey Run pics
by Mk3rob Wed Jan 03, 2018 9:22 pm

» Anyone know these scamps?
by Rum Tum Tugger Thu Dec 28, 2017 9:12 am


Bulging Chassis Tubes.

View previous topic View next topic Go down

Bulging Chassis Tubes.

Post  Steve G on Tue May 06, 2014 11:05 am

.


Last edited by Steve G on Mon Jan 05, 2015 2:30 pm; edited 1 time in total

Steve G

Number of posts : 336
Location : .
Job/hobbies : .
Registration date : 2014-02-26

View user profile

Back to top Go down

Re: Bulging Chassis Tubes.

Post  Mk3rob on Tue May 06, 2014 4:27 pm

I think it really depends on how load bearing they are.

I had a couple that were starting to go that way.
Mind you a 3lb club hammer and a coat of paint worked wonders.

Mine was not on a restoration at the time mind you, oh and I cant weld Rolling Eyes 
avatar
Mk3rob

Number of posts : 2260
Age : 61
Location : Wolves
Job/hobbies : DIY, Cars, reading and survival!!
Registration date : 2008-05-19

View user profile

Back to top Go down

Re: Bulging Chassis Tubes.

Post  Steve G on Tue May 06, 2014 4:56 pm

.


Last edited by Steve G on Mon Jan 05, 2015 2:30 pm; edited 1 time in total

Steve G

Number of posts : 336
Location : .
Job/hobbies : .
Registration date : 2014-02-26

View user profile

Back to top Go down

bulgies

Post  Ferretboy221 on Tue May 06, 2014 8:11 pm

I had one on the very rear left hand upright of my mk2 obviously been full of water and frozen (it lived outside in the middle of a go kart track for several years) I ended up slitting the corner with a 1mm disk flattening the corresponding faces and grinding any excess due to stretching and then welded the corner - tidied up, you wouldn't know anything had happened and is still as strong as its fully welded.
avatar
Ferretboy221

Number of posts : 134
Age : 30
Location : Southern Cumbria
Job/hobbies : Land rover Indie mechanic/parts guy, Scamps of course.
Registration date : 2009-03-23

View user profile

Back to top Go down

Re: Bulging Chassis Tubes.

Post  Sponsored content


Sponsored content


Back to top Go down

View previous topic View next topic Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum